Autotrol i Manual – Free download as PDF File .pdf), Text File .txt) or read online for free. Valve Exploded View. Valve Parts List. Performa Exploded View. Performa Parts List. Logix Series Controllers Parts List. TROUBLESHOOTING. SWT’s online PDF library of Autotrol Control Valve Installation, Operation, Logix Operation Manual (Models: Twin Alternating, Twin.
|Published (Last):||9 September 2004|
|PDF File Size:||1.70 Mb|
|ePub File Size:||17.80 Mb|
|Price:||Free* [*Free Regsitration Required]|
Autotrol User Manuals
If the ball doesn’t seal against its seat you may get water into the salt tank. There is no check valve anywhere inside the Autotrol I also have an Autotrol – and the brine tank is consistently overfilling.
The Autotrol part number of ATthe valve body that sets on top of the tank adapter module looks to be around All times are GMT It sounds as if you need a set of new flapper valves, especially the brine pair. I replaced all the flapper valves and everything works fine now.
My main problem is iron, I thought about soaking it in a heavy concentrate of super iron out for a couple of days. Any advice would be greatly appreciated! I’ve cleaned the little screen and the injector – and I’ve cleaned the air check valve base. So I will get a rebuild kit and try that. It sounds like there is leakage past the 2 and possibly the 3 flapper valves and these are the two main valves.
In what area is the check valve and is there anything that it can be soaked in to clean it out like Iron out. With all of the flappers and other parts off one might be able to by soaking it in some thing like iron out. I’ve never seen a bad ball. Autotrol won’t draw brine Printable View.
When it is free anyway. Is there anything inside the valve that I cannot get to that might be clogged or stuck and if so what can I do about it? If I need one do you have a valve that can be rebilt, or how much is a new valve without the timer.
You don’t need any new module etc. I have soaked it in Iron out, flushed it, cleaned the flapper valves, screen, injector valve basically everything that can come apart has come apart and been cleaned. What kind of water quality are you deal with? I will have to manaul one of the valves that I have in the pile, see what it sounds like.
I will let you know the results, thanks.
Can you hear the valve move if you shake the valve body? I have an Autotrolthe problem I am having is it is not drawing brine in fact during the brine cycle it flows a small amount of water into the autohrol tank instead of creating the suction needed to draw brine out of the tank.
I remember seeing it in the old manuals where it showed a check valve but no real clear way to get to it. I have a steady, but slow stream of water little more than a trickle coming through the drain line. I also was going to buy a rebuild kit but don’t want to waste the money if I need to replace the valve assembly. Thanks for all the helpful advice.
After putting it auttotrol together and installing it back on the tank it still won’t siphon brine and actually water comes out of the brine well tube. Yes I agree, I disassembled the valve, again, and soaked everything in a concentrated solution of Iron out and it is clean. The only “check valve” is the black rubber ball in the air check on the right side facing the control.
Water Softener Manual | Autotrol | Aqua Tech Water
The air check is where the brine line going to the salt tank is connected to the control valve on top the air check. The time now is While looking at the parts brake down of that valve, I 25 that there are some O rings between the two parts. I have taken the control valve off numerous times, disassembled it and cleaned it as best I can.
Originally Posted by kpreilly.